The closest is FAT file system, which is decidedly not modern. Download and install FUSE-Ext2 as described here and then run something like. There is no easy to use, reliable, and modern file system that is full featured on all three major platforms: Windows, Mac, and Linux. In my opinion, the state of affairs of disk formats is really quite sad when it comes to cross-platform interoperability. I used GNOME Disks to format just the volume to Ext2/3/4, without erasing and re-partitioning the disk. Note that if you format the drive in GParted - Gnome Partition Editor, it may inadvertently partition it in some Linux format that Macs cannot read at all (Mac OS X will prompt you to initialize the drive, thus erasing all data). I could not get it to mount in read and write mode. Then a volume created within that partition scheme that is formatted as Ext2, Ext3, or Ext4, can be mounted in read-only mode on a Mac (given the above two software are installed). I did some testing on this, and found that technically, a USB Flash drive whose partition map scheme reads as Master Boot Record in Apple's Disk Utility program, equivalently, its partition type reads as W95 FAT32 in GNOME Disks (née GNOME Disk Utility, née Palimpsest), is required. Fuse-ext2 is a multi OS FUSE module to mount ext2 and ext3 file system. The tricky part is actually to find a USB Flash drive formatted correctly. For use OSX fuse in the automount tools, we need to set the next kernel variable. More Fuse-ext2 documentation is available. (you may have to choose this explicitly under custom install within the Fuse-ext2 is a multi OS FUSE module to mount ext2 and ext3 file system devices and/or images with read write support. Sure to install the MacFUSE compatibility layer when installing OSXFUSE Which is no longer maintained and should be considered outdated. Com/alperakcan/fuse-ext2 FUSE for OS X Extends macOS via third party file. The software you'll need to install are, in this order: 4 Download and install FUSE-Ext2 as described here and then run something like mkdir /Volumes/Linux sudo mount -t fuse-ext2 /dev/disk2s6 What does Fuse for. Connect the NTFS drive to your Macbook and allow OSX FUSE when asked for. I could only get it to work in read-only mode though. It turns out the same software (TrueCrypt being optional) can let you mount USB Flash drives in those formats as well. As I've written in Mounting TrueCrypt Ext2/Ext3/Ext4 Volume on Mac: Read Only Success, it is possible to mount TrueCrypt volumes formatted as Ext2, Ext3, or Ext4. fuse-ext2 works but is very slow (I get some 7 MB/s reading and 1 MB/s writing via USB 2.0).
0 Comments
Leave a Reply. |